STM32F10x Standard Peripherals Library  3.5.0
Data Fields
SPI_InitTypeDef Struct Reference
SPI_Exported_Types

SPI Init structure definition. More...

#include <stm32f10x_spi.h>

Data Fields

uint16_t SPI_Direction
uint16_t SPI_Mode
uint16_t SPI_DataSize
uint16_t SPI_CPOL
uint16_t SPI_CPHA
uint16_t SPI_NSS
uint16_t SPI_BaudRatePrescaler
uint16_t SPI_FirstBit
uint16_t SPI_CRCPolynomial

Detailed Description

SPI Init structure definition.

Field Documentation

uint16_t SPI_BaudRatePrescaler

Specifies the Baud Rate prescaler value which will be used to configure the transmit and receive SCK clock. This parameter can be a value of SPI_BaudRate_Prescaler.

Note:
The communication clock is derived from the master clock. The slave clock does not need to be set.

Definition at line 71 of file stm32f10x_spi.h.

uint16_t SPI_CPHA

Specifies the clock active edge for the bit capture. This parameter can be a value of SPI_Clock_Phase

Definition at line 64 of file stm32f10x_spi.h.

uint16_t SPI_CPOL

Specifies the serial clock steady state. This parameter can be a value of SPI_Clock_Polarity

Definition at line 61 of file stm32f10x_spi.h.

uint16_t SPI_CRCPolynomial

Specifies the polynomial used for the CRC calculation.

Definition at line 80 of file stm32f10x_spi.h.

uint16_t SPI_DataSize

Specifies the SPI data size. This parameter can be a value of SPI_data_size

Definition at line 58 of file stm32f10x_spi.h.

uint16_t SPI_Direction

Specifies the SPI unidirectional or bidirectional data mode. This parameter can be a value of SPI_data_direction

Definition at line 52 of file stm32f10x_spi.h.

uint16_t SPI_FirstBit

Specifies whether data transfers start from MSB or LSB bit. This parameter can be a value of SPI_MSB_LSB_transmission

Definition at line 77 of file stm32f10x_spi.h.

uint16_t SPI_Mode

Specifies the SPI operating mode. This parameter can be a value of SPI_mode

Definition at line 55 of file stm32f10x_spi.h.

uint16_t SPI_NSS

Specifies whether the NSS signal is managed by hardware (NSS pin) or by software using the SSI bit. This parameter can be a value of SPI_Slave_Select_management

Definition at line 67 of file stm32f10x_spi.h.

The documentation for this struct was generated from the following file: